Our Power Vent (TTW®) models are power vented for positive exhaust. They offer greater installation flexibility with the ability to vent through a wall or roof, with either 2 or 3 in PVC, ABS or CPVC pipe. They offer an increased amount of hot water available at a usable temperature in less time than normal.
Bradford White® Defender Safety System® Gas Water Heater, Series: TTW®, 75500 Btu/hr Heating, Propane Gas Fuel, 1/2 in Gas Connection, 75 gal Tank, Pilot Ignition, Power Vent, 3 x 4 in Vent, 82 gph Recovery Rate, 0.8 Energy Factor, 3/4 in NPT Water Connection, 150 psi Pressure, Ultra Low Nox: No, 26 in Dia x 30-11/16 in D x 69-7/16 in H Dimensions, Domestic
Dimensions |
: |
26 in Dia x 30-11/16 in D x 69-7/16 in H |
Domestic/Import |
: |
Domestic |
Energy Factor |
: |
0.8 |
Fuel Type |
: |
Propane Gas |
Gas Connection |
: |
1/2 in |
Heating Capacity |
: |
75500 Btu/hr |
Ignition Type |
: |
Pilot |
Pressure Rating |
: |
150 psi |
Recovery Rate |
: |
82 gph |
Series |
: |
TTW® |
Tank Capacity |
: |
75 gal |
Ultra Low NOx |
: |
No |
Vent Size |
: |
3 x 4 in |
Vent Type |
: |
Power |
Water Connection |
: |
3/4 in NPT |
- Bradford White® ICON System™: Intelligent gas control with spark to pilot ignition system eliminates the constant burning pilot, this results in savings of pilot gas during stand-by periods (120 VAC)
- Enhanced performance: Proprietary algorithms provide enhanced first hour delivery ratings and tighter temperature differentials
- Advanced temperature control system: Microprocessor constantly monitors and controls burner operation to maintain consistent and accurate water temperature levels
- Intelligent diagnostics: An exclusive green led light prompts the installer during start-up and provides ten different diagnostic codes to assist in troubleshooting
- Power vent water heater: Designed for installations where atmospheric units cannot be used, exhaust gases are vented under positive pressure directly out of the building through the roof or the wall
- Powerful blower motor: Our significantly quiet design has greater resistance to outside winds and the power to vent in many difficult venting situations
- Horizontal and vertical venting: PVC, ABS or CPVC
- Advanced ScreenLok® technology flame arrester design: Flame arrester is designed to prevent ignition of flammable vapor outside of the water heater
- Flammable vapor sensor: Electronic sensor prevents burner operation if flammable vapors are detected
- Maintenance free: No regular cleaning of air inlet openings or flame arrester is required under normal conditions
- Sight window: Offers a view into the combustion chamber to observe the operation of the pilot and burner
- Factory installed Hydrojet® total performance system: Sediment reducing device that also increases first hour rating of hot water while minimizing temperature build-up in tank
- Vitraglas® lining
- Insulation system: Non-CFC foam covers the sides and top of the tank, reducing heat loss, this results in less energy consumption, improved efficiencies and jacket rigidity
- Water connections: 3/4 in NPT factory installed true dielectric fittings extend water heater life and simplify water line connections
- Factory installed heat traps: Design incorporates a flexible disk that reduces heat loss in piping and eliminates the potential for noise generation
- Low restriction brass drain valve: Durable tamper proof design
- Thermostatic mixing valve (ASSE approved)
-
Installation Manual
https://www.capitolgroupinc.com//ASSETS/DOCUMENTS/ITEMS/EN/RG Power Vent Install Manual.pdf
-
Parts List
https://www.capitolgroupinc.com//ASSETS/DOCUMENTS/ITEMS/EN/RG Power Vent Parts List.pdf
-
Service Manual
https://www.capitolgroupinc.com//ASSETS/DOCUMENTS/ITEMS/EN/RG Power Vent Service Manual.pdf
-
Specification Sheet
https://www.capitolgroupinc.com//ASSETS/DOCUMENTS/ITEMS/EN/RG Power Vent Spec Sheet.pdf
-
Technical Bulletin
https://www.capitolgroupinc.com//ASSETS/DOCUMENTS/ITEMS/EN/RGPV_QSG.pdf
-
Warranty Information
https://www.capitolgroupinc.com//ASSETS/DOCUMENTS/ITEMS/EN/RGPV_Warranty.pdf